Maybe but not always. It could also mean that the fill tube is full of frozen ice and the water cant get to it. You can actually get behind the machine, take the the 1/4 in screws iut and check the tube to see if this is happening. If you have no ice in the tube the next thing to check is when the ice maker is cycling, get behind the machine, and see if the water valve vibrates at some point, it will actually make a buzzing sound. If this happens and no water then the valve is bad, if it does not happen then the ice maker is bad and not calling for water. You can actually manually advance the ice maker by removing the front cover off it, and getting a jumper wire and going from holes n and m on the upper right side.
Suggested Questions/Answers :
It is recommended you read all this kind of situations
Automatice icemaker is cycling but the unit is not calling for water. Doest that mean the dual water inlet valve needs to be replaced
Maybe but not always. It could also mean that the fill tube is full of frozen ice and the water cant get to it. You can actually get behind the machine, take the the 1/4 in screws iut and check the tube to see if this is happening. If you have no ice ...
Kenmore Icemaker Leaking! Is the water control valve and the water inlet valve the same thing? Water is slowly leaking into the icemaker tray and causing build up. I just need to know which one to replace. Kenmore 106.56582500 Thanks, Terry
Replace the dual water inlet valve . The piece the line from the wall connects to . ...
Sub-Zero 30.1 cu. ft. Cabinet Depth Side-by-Side Refrigerator 632 / F
Whirlpool side by side Mod.# ED25DQXDW02. No water getting up to icemaker. I believe I need to replace Water Inlet Valve. I show replacement part AP3085178? Does that sound right to you? How difficult are they to install. Thanks, Scott
This could be two things, your water inlet valve or your filter is clogged. I would check both. if the filter lets water pass freely then you will need to replace the inlet valve, two 5/16th screws on the back that holds the inlet valve in place. Ver ...
Model #7gs6shexpq00 infrared icemaker. I replaced the dual water valve, did not fix problem. No water goes into ice tray. The unit is in Merxico so I need advice as tomwhat part I need to take there.
Hi.To start ensure that the problem is not caused by frozen water in lines. This is common cause for this problem.You can attempt defrosting the lines with an hairdryer once in site, but better asking to perform a full defrost ...
I have a Whirlpool side by side fridge, model GC3PHEXNS02. The icemaker stopped working one week ago. I just replaced the dual water inlet valves, but the icemaker is still not working. The infrared switch is "ON"; it flashes when the beam is blocked (door open), and remains lit when exposed to the beam. The water dispenser on the door does work.
The general rule is to put 2/3 cup of water into icemaker , and if it dumps , but doesn't fill , replace the water inlet valve . If it doesn't dump , replace the icemaker Pt # 2198597 . Check the black fill tube above the icemaker fill cup , to see i ...
Replace water inlet valve for ice dispenser with new. When icemaker cycles it dispenses through the water dispenser instead of tube going to ice maker. I have switch lines around but can only get water dispenser to work normally.I have wirlpool side by side model # ED5GTFXKQ02.
The ice maker is what tells the water control valve to open so it may be correct now and the thermostat in ice maker may be defective. Part 27 or ...
The refrigerator is a Model frs26zseb purchased in 1997. It has worked well until now
The icemaker is not getting water.
I have replaced both the inlet valve and the icemaker.
All tubing has been checked and is open.
There is good water flow to the water dispenser and if I reverse the connections to the water inlet valve I have good water flow to the icemaker
Temperature in the freezer is between -5 and 10 F but the refrigerator rune constantly.
What is left to check?
Wow with a new water valve and a new ice maker and temps below 20 f in the ice box that puppy should drop ice. Add some water to the ice mold and see if tosses out a batch. Check your water pressure. Did you turn the water supply back on? Probably so ...
I have a Whirlpool model # ET1CHEXVB00 refridgerator. I just (few minutes ago) replaced the ice maker valve because water was no longer getting to the icemaker. Very shortly after I plugged the refridgerator back in and turned on the water, the icemaker went through one cycle and some water (mayber quarter cup) ran down the inside back of the freezer cabinet. Also one time recently (before I decided to replace the icemaker valve), I found several cups of water on the bottom of the freezer cab
Sounds like the fill tube at the ice maker is either out of alignment or has a crack in it.\012The water supply line from the water inlet valve \012enters the rear of the freezer and release ...
Whirlpool 21.0 cu. ft. Top Freezer Refrigerator with IceMagic Plus Ice Maker
I own a Kenmore Coldspot, Model 10657572790, Manuf. 7-97: I recently replace the dual-Valve Water Valve. Before I replaced the valve, the water function in the don't work, but it did make ice. Now, the water works, but it don't make ice now? I call the company where I purchased the valve, and the told me that I needed to bleed the line and still water travels through the tubing for the ice maker. I can pure water in the ice maker and it works great, but water isn't pumping from the new valve to
Wirlpool fridge icemaker over flows, never stops running, must shut off water to stop the flow. replaced the dual water valves and still the same.
Maytag MSD2756GEW went from hollow ice to no ice. Water dispenser works fine, good pressure, new filter, etc., fill line doesn't appear frozen. Replaced water valve to icemaker. When refrigerator plugged back in, icemaker cycled and dumped remaining ice but no hum with water refilling icemaker -- icemaker appears to work fine, other than NOT refilling with water and making ice. :) Also, waited a couple of hours, still no ice. Jumpered ''T'' & ''H'' to force cycle, arm rotated as did dial on fron
I assume the water valve you replaced is the fill valve located within the refigerator.\015\012\015\012If so, I suggest that you check the saddle needle valve on your water supply pipe - (generally in the basement). It may have finally c ...
Maytag MSD2756G Side by Side Refrigerator
I have a Kenmore Side By Side Fridge 106.56596501 - 3 1/2 yrs old and the icemaker has stopped working. Checked the ice maker unit inside freezer, replaced water inlet valve, replaced clear tubing to icemaker, replaced water filter, checked for ice blockage in tubing and still nothing. No noise similar to what we used to hear when the water flowed into the ice cube tray. Water dispenses fine through front door dispenser. Any thoughts?
TFX22KRCE AA Hey guys! We have had GE forever and need some assistance. Above refrig with icemaker...no filter....no ice at all but icemaker cycles. Replaced icemaker with same results...icemaker cycles. Fill up tube not frozen. No water gets to tray. Good pressure to water dispenser What may I do?
Check your valves. Are the lines to the I/M on the outside of the fridge and are they in good condition? If you can, switch electrical connections on the valves then call for water. If water enters the I/M then you probably have a wiring issue since ...
Ed25rfxfw01 whirlpool fridge water dispenser ...I have a slow drip from the dispenser hose. I assume I need a new water inlet valve. How do I access the inlet valve for replacing?
It should be on the right hand side in the back take off the compressor cover on the back should be 8 or so 1/4 screws nutdriver type and then two more hold on the water valve. If you have a RO system hooked up to refrig you may need to change the f ...
Whirlpool 25.6 cu. ft. Side-by-Side Refrigerator with In-Door-Ice Dispensing System
I Have a GAGGENAU RS495 310/05 Refrigerator and its icemaker doesnot produce ice , i have changed three times the ice maker by new but the problem remains , the ice maker does its circle normally but it does not give order to fill water. Recently i 've installed a brand new icemaker , checked the Dual Water Inlet Valve and it is working , inlet pipe has been checked and has no ice , but still no water coming into the ice maker when it is ordered to. Any ideas please because the technicians t
I am going to replace a dual water valve with a single water valve on a Whirlpool Gold refrigerator. The reason for changing the valve is that the house has low water pressure and the water dispenser leaks when the pressure gets too low. My question is this: is the water line to the icemaker larger than the water line to the dispenser?
Good day,\015\012No. In fact it is the other way around. The water feed is the larger of the 2 lines.\015\012In some areas I service, the water pressure is too low for even an ice maker to function,at least properly. \015\012However ...
I have a GE side by side Model: TFX27PRXD WW Serial: SR237995. No water is reaching the icemaker. Previously it would periodically begin to work then stop and start again. I replaced the water inlet valves for the icemaker and water dispenser, but the icemake still gets no water.
Is the freezer cold enough? Should be close to 10 degrees. Is there water or ice in the ice mold? If not put water in it and see if it dumps the ice after it’s frozen. If there is ice, lift the cut off arm and let it drop to see if it wi ...
GE (PSS26MSRSS) Side by Side Refrigerator
MY WATER INLET VALVE SPRUNG A LEAK SO I ORDERED A NEW ASSEMBLY. THE OLD ASSEMBLY IS THREADED SO THAT THE LINES FROM THE FRIDGE SCREW ON TO THE BOTTOM OF EACH VALVE. THE REPLACEMENT ASSEMBLY HAS SOME TYPE OF PUSH IN COLLARS AND I'M TOLD THAT THIS ASSEMBLY IS THE CORRECT REPLACEMENT PART AND THE OLDER SCREW ON TYPE IS NO LONGER MADE. I'M BEING TOLD THAT I NEED TO CUT OFF THE END OF MY PERFECTLY GOOD WATER LINES TO REMOVE THE PLASTIC NUT AND FERUELL AND THEN JUST PUSH THE END OF THE HOSE INTO TH
The push-type connector work very well. They eliminate the need to twist wrenches in often times tight locations when installing and removing these lines.It is important that any part of the old lines that will be inserted into the new " ...
What is the purpose of protrusion on this valve over old style WR 57x90? The water inlet valve for GE icemaker leaks when only connected to water , no electrical or outlet tubing. Valve has been replaced twice with new one -- one was a UR , second one GE WR 57X95. Water system has three filters- no residue when run into glass. Can a WR57X90 or Whirlpool 4318047 be used??
All I know of is the valve body is blue on some models. Does the water line connect to it and out to the ice maker from it? ...
Whirlpool gold side by side ice maker not making ice... have replaced the ice maker... still not working, no water to unit... not frozen up... water dispenser is working fine… was recommended by Bogie Boy: You have a dual solenoid water valve. Blue for the water and red for the ice-maker. It located in the rear lower part of the frig. The water solenoid needs replacing that will solve your problem… I did that and it fix the problem… I had ice… but only for about 2 weeks. Now no ice again!
Whirlpool GD5SHAX Side by Side Refrigerator
I have a Whirlpool GD5SHAXLQ02 side by side refrigerator which is 7 1/2 years old. I replaced a kitchen faucet and in doing so, needed to shut off the water supply to the refrigerator. When turning the water back on to the unit, the ice maker suddenly stopped working. It wouldn't fill with water. First, I checked for a frozen inlet tube in the freezer which seemed fine. Next, I tested the continuity on both sides of the inlet valve. I've never used a multimeter before and am not sure if I used i
I wonder if there is a blockage or an air lock in the water feed. Can you disconnect the feed and get someone to blow down the end of the tube connected to the fridge as you press the switch?While disconnected also make sure that there is a flowing s ...
Whirlpool GD5SHAX Side by Side Refrigerator
No water in icemaker just replaced icemaker and water inlet valve, water is on power is on
The Ice maker has a metal trigger arm on the side of it. If the trigger arm is up, the Ice maker will not make Ice. Gently lift the trigger arm all the way up and then set it all the way down. No force is required if the arm is working. This info sho ...
I have Kitchenaid KSRS25CNSS refrigerator and the icemaker doesn't make ice. No water is getting to icemaker. Also, the red laser light is off and icemaker motor continues to cycle repeatedly. Don't know what to replace...water control valve, laser light, motor, wiring harness, or all?
Sounds like the ice maker control board is bad if all of that is going wrong otherwise I would think the water valve if you didn't have the other problems.It is the second part on the following website link for the control module that you ...
I have a kitchenaid kscs25inss00, I checked everyting. Water lines, changed filter, checked valve, ice maker control optics. Everything is working. I also used a Jumper for holes ?T? and ?H? to bypass the bimetal and start a harvest. The ice maker works only for one cycle. Then it stops in 10-11 Am position. What do I need to check, what do I need to replace? Please help. I also checked the ice maker, heating resistence and the timer. Everything seems to work for the duration of one cycle, then
KitchenAid Superba Architect KSCS25INSS Side by Side Refrigerator