Suggested Questions/Answers :
It is recommended you read all this kind of situations
Upon first startup, Compressor runs for 10 seconds then continuously cycles on and off repeatedly. Unit is a Norcold N641 dual voltage 120vac/12vdc unit that is used in our boat. Switching supply vo
Thetford Norcold 2-way RV Refrigerator N641
Norcold N821 Refrigerator. Built after 11APR06.
When using A/C voltage I get an error code "A." I had to reset the unit to get the gas portion to function. on the diagnostics menu it says A/C power is not present. I have 115 VAC present at the fuse. The fuse is good at 0.1 ohms. Is there a schematic available for the circuit board? I would rather replace a component than spend $200.00+ on a new module. Thank you for your assistance.
Yes there is a schematic but it may not be the best approach to the solution. You may be losing a chip on your board because of what I call bad batch and Quality Control failure.Also the boards owner may not want their board ...
I have inherited a Kenmore side-by-side refrigerator with a manual that says the model is 106.5702*601 or 106.5703*601. This model has a built-in filter with "push button" replacement at the bottom of the unit. Instead of using this filter, I wanted to install my own in-line filter. Following the directions, I turned off the water supply; cut the plastic water line (at the back of the unit that runs from bottom to top); and turned on the water supply to test. To my surprise, no wat
He may have re designed it just as you are trying to do. look for a second line.Also the water may be frozen or clogged if it is still cold.let the water run for a while it may or does have a tank to store water in that's how she keeps it cold, allow ...
I have a Norcold 323 Refrigerator in a camper that will not cool when operating on AC but does work on gas, ( I cant test the DC as I dont have a 12 volt power sorce). After running in on gas for a while I whitched over to AC and it appears to be running. What could be the problem?
The unit is only used a couple times a year since it was purchased in 2005 and hasent been used for the past year. Does the unit require a jump start with the gas after sitting unused for long peroids of time
Thetford Norcold N323 1.7-cu ft 3-way Built-in Refrigerator
Norcold n611rt My fridge sends a code compressor will not come on. I know this is an ammonia fridge and does not have a compressor, but uses a heating element. I reset the fault code by putting a ground from the empty pin connector next to the purple and white wire to ground and turned the unit on on. i heard the click and the unit cycled but still won't pull the temperature down.
I have a whirlpool side by side refrigerator (model # ED25TW) and my icemaker has a number of ( IM#S 106 626636). My problem is that the water is overfilling the ice tray. My question is can I adjust the length of time the valve is supplied voltage. It appears that the icemaker has two adjustment screws located in the front panel (one in front, and one on the side of unit). please advise if one of these control the time length of voltage to the inlet valve. If so, which one and what directi
I have a Whirlpool GD5SHAXLQ02 side by side refrigerator which is 7 1/2 years old. I replaced a kitchen faucet and in doing so, needed to shut off the water supply to the refrigerator. When turning the water back on to the unit, the ice maker suddenly stopped working. It wouldn't fill with water. First, I checked for a frozen inlet tube in the freezer which seemed fine. Next, I tested the continuity on both sides of the inlet valve. I've never used a multimeter before and am not sure if I used i
I wonder if there is a blockage or an air lock in the water feed. Can you disconnect the feed and get someone to blow down the end of the tube connected to the fridge as you press the switch?While disconnected also make sure that there is a flowing s ...
Whirlpool GD5SHAX Side by Side Refrigerator
KitchenAid KSCS25INSS01 ice maker intermittent failure. It periodically stops making ice for days. I noticed it occurs when there is heavy use on the RO unit that supplies it. The drop in water pressure causes the ice maker to slow down and then the water in the line feeding it freezes. I had a tech come out once to defrost the supply line in the freezer above the ice maker. It seems however, if I could start a defrost cycle the line would free up. That must be the explanation for the observatio
No you dont want to go there !there is a chance that your water valve is dripping and water are in the line...also there is a heating kit for your fridg that prevent that ask your local tech. ...
KitchenAid (KSRD22FKST) Side by Side Refrigerator
My whirlpool ed27dqx refridgerator quit making ice immediately after I had my reverse osmosis drinking water system upgraded. I replaced the ice maker unit and the dual water valve. I have always had water at the drinking water at the front of fridge, but no water flows into the ice tray. Did I get a bad valve, is there air in the line, do I have an electrical problem, or what? Do both solenoids on the valve have the same voltage so I can switch power between solenoids?
The pressure from a reverse osmosis system is not sufficient to operate the ice maker water valve. A water valve requires a minimum of 20 pounds of pressure without a refrigerator water filter, and 35 pounds of pounds of pressure with a refrigerator ...
Have installed voltage controller with w103102240 had 12920721. both maytag numbers. cannot program code 2020 in too unit.
shows only pe0 000. when hitting up ref temp shows pe h20 and down temp pe ice. cant get nothing to work. installed circut board and have left alone for about 2 hours, still won.t program, using paper that came with reff for instructions.
Maytag MFI2569VE Bottom Freezer French Door Refrigerator
Just replaced a dual valve solenoid on a Fridgidaire refrigerator. The water supply seems to be working except when I use the in-door water dispenser. The water pours out through the bottom of the ice maker instead.
Now that strange chain of events! Just would be so helpful if you could ge me a model number of your Frigidaire. Has someone done any work or repairs that may have changed directions of wiring? Thing is I really need that model number mo ...
I just took delivery on an LG LMX25984 french door refrigerator. No water is dispensed. Followed the instructions to purge air from the system by depressing the water dispenser arm. I can hear the sound of the dispensor operating, buf after 5 minutes, still no water.
I checked again, and yes, there is water in the supply line. I noticed a 12VAC solenoid at the bottom rear of the unit. Did not seem to be energized. Placed a meter on the solenoid connector - no voltage at all.
So what c
Its called solenoid valve.If the solenoid valve not functioning then check the power /voltage.If there is no voltage then it has to be replaced.but as you said its new then its under warranty.Ask the company to get it replaced.many a times the soleno ...
LG LFX25960ST Stainless Steel French Door Refrigerator
I have a side by side that I puchased just about two years ago. The unit serial # is MT225306. My problem there seems to be a low voltage source to the freezer fan. I use a nife and push the fan to get it statrted when it calls for it to run and then it works Ok. If i hit the Ice cube dispensore or anthing on the door the fan quets and will osolate and then with a slight push I can get it going again. Also when the ice cube maker is on it pulsate as it seems to be kicking a relay on and off. I a
The Kenmore Ice maker makes no ice. This is a side by side unit. The freezer is very cold. The water solenoid is not faulty, but is not turning on so the problem must be in the electronic ice level detection boards or the wiring to the solenoid. (The water in the door works fine... so I tested the ice water supply solenoid using the water in the door control... and the ice solenoid turned on when the water in the door dispensor lever was activated)... The LED light on the ice maker comes on when
Good chance the water line near the ice maker motor is frozen. Thaw out the freezer for about 6 hours - move your frozen stuff to the refrig - ot should be OK - then back again after thawing. This alnost always works. ...
I own 2 of the vs220 seal-a-meal units one of which worked ok with the bags that came in it and the second is a hit and miss unit. Both were purchased at walmart. I have tried to use the last one that i purchased one time to seal fish. That unit just won't vaccume the the bags down to well and I had someone try there hand at it who owns a really good one. My other unit is used to seal on sale meats but the bags that walmart sold me don't vaccume down very well before the unit goes into the seali
I too bought my seal a meal at Walmart. I have gotten it to work twice. The main problem is it won't seal. I really think it has to do with the black seals....If I pull them up it sometimes will work. It is really frustrating. I would take it back bu ...
Applied power to a Shinco KFR-50GWZ/BM and there is an ERROR CODE "P0" on the inside unit display. I checked the voltage at the unit and there was 209.9 vac there. Checked name plate info for the unit and it is 230 vac. Would the low voltage here cause this error? If so I can get the Power Company to change the tap on the Transformer to give me 230 vac. I see on a chart that this ERROR CODE "P0" indicates DRIVER BOARD IS FAULT. Where is the DRIVER BOARD located and can this fault be reset?
Unit has cold water dispenser and ice maker. The cold water flows without a problem but water is not getting to the ice maker. We have not changed the water filter in the unit because we have a pure water supply. Does the filter supply only the ice maker. If so does the filter monitor turn off water to the ice maker if it is past due for a new one?
If the filter supplies both the cold water dispenser and the ice maker, why is only the ice maker not getting water. We see no leakage of water whic
The filter should go to both your water dispenser and the ice maker. There is a electrical solenoid valve that controls the flow of water to your ice maker and on the inlet side of the valve there is a fine mesh screen that I would check. I doubt tha ...
GE Profile Top-Freezer PTS22LBNARCC
Unit was working great using settings 5 freezer and 5 refrig until 2 weeks ago.
Now with 5-5 settings freezer goes to -25F and refrig 25F. Evap fan is running and blowing cold air, no problem with not being cold in freezer or refrig. I have made sure that vents at the back of the freezer that allow the cold air into the refrig are not blocked. I have turned unit off for 2+ hours and then restarted unit using settings of 2 for freezer and 2 for refrig. Freeze
In order to ensure proper temperatures, you need to permit airflow between the refrigerator and freezer sections. As shown in the illustration, cool air from the refrigerator enters through the bottom of the freezer section and moves upward. Mo ...
Refrig cooling Unit loosing cooling in freezer and most likely main compartment too. No iceing up, coils were dirty, cleaned them. It does cool correctly for a while then stops blowing cold air before everything is frozen. Compressor seems to be ok. I think is may be a temp sensor. Old unit, maybe 15 years old, used in the garage for extra storage. Unless it's a cheap part I don't see the use in repairing it. Your thoughts?
Suggest turn off, defrost overnight with the doors open restart following day should work within 24hrs, if not possible refrigerant gas leaked out and probably not worth re-gassing at that age of unit.\015\012Regards\015\012Advisor ...
Water dispenser sudden low flow/pressure. Bottom freezer KBFA25ERss. I have replaced valves, removed every segment of line and blown them clear from dispenser tip to supply line. Supply pressure and flow is fine, filter is new, reservoir not frozen, etc. Pressure seems to build when not in use and flow is fine for a short while. Pressure drop is sudden when the built up pressure or volume is depleted. Amount of good flow time is proportional to the amount of time left alone not in use. Aft
Sounds to me you have something wrong with the filter and retaining air there. That air must be purged to get the pressure you need from water supply. Double check that water filter I think your problem is there, Thanks ...
KitchenAid Architect KBFA25ERSS Stainless Steel French Door Refrigerator
Help! In 2006 I purchased a used RV with a dometic model 2408 refrigerator that did not work. After reading up on Absorption refrigerators and repair facilities I had it rebuilt by RV Mobile in Everett, Washington. I re-installed the unit in our RV and turned it on (we use the gas side). I checked it the next day and both the freezer compartment and the refrigerator portion were working well. The next day we arrived for a three week trip and with food for the unit and found it not working. The
The evaporator coil is usually located in the freezer compartment, and there are ducts with dampers that send cool air to the refrigerator. It sounds to me like that may be your problem. It seems that if you move the appliance around a little, (cle ...
Dometic RC3000EGP quit cooling, completely. I believe the refrigerant has leaked. Yellowish residue. I have always vacuumed back, wiped with a damp cloth and totally cleaned the unit after use. I have only used the unit once or twice a year to a fly-in fishing trip. Worked great, electric at home, car plug-in on the road and propane when we arrived in camp. Help!
Model # frs6l9efss3 bought unit used plug unit in