Suggested Questions/Answers :
It is recommended you read all this kind of situations
I have a sub-zero 532 and need to replace the light switch. I need instructions on how to change the switch
How do I replace refrigerator light switch on Sub Zero 590? Does it just pop out or do I need to remove the panel?
Http://store.4appliancerepairparts.com/servlet/-strse-6795/16009-621038-751228-7516450/DetailThese switches snap into place. Carefully remove them by releasing one side so the panel is not damaged. The above URL will have a picture of a s ...
Sub Zero 690 replaced lights but fan and lights dont work
The fan will only run when the compressor is running. Check it a couple of times to see if it actually is not going on. There is alos a light terminator located behind the fan cover. We will assume it is the light switch. For the light switch go to ...
Sub-Zero 690 Side by Side Refrigerator
I have an AEG Santo R600A larder fridge which I bought from John Lewis some years ago. The light is no longer working and I need to replace it, which I shall do at a spare parts shop. Unfortunately I have mislaid the instruction manual and do not know how to replace the light. Please can you give me some instructions.
This issue is regarding Sub zero 695--side by side with mechanical parts on the top----and in-door ice/water dispenser (and light switch). They are touch triggered. The ice will dispense and the light will turns on. But, when the water dispenser button touched, the flap will open, the light comes on but no water. After a few second, the flap noise (opening the flap) but no water---light switch is not on lock position. The flap closes after 10 sec. and light turns off.
Is this a water valve prob
Sub-Zero 695/O Side by Side Refrigerator
Sub Zero wine refrigerator model 424. Not cooling. The solenoid that engages/cycles the refrigerant is not kicking in. I have vacummed beneath the door per instructions. When pushing the light and on/off buttons I get the following error codes: 12 EC 10 EC Which tell me that the upper and lower temps are too high (duh). Service indicator light is NOT on. In the past I have had the computer board replaced and one of the thermistors replaced. Any thoughts?
I have a Fridigaire Refrigerator model #GLHS36EESB2 - not defrosting. Replaced defrost thermo and defrost board part #5303918341 which was a replacement for the original. (Meaning different wiring). Replaced three days later called back - frosted up again. Tried to initiate defrost cycle by pushing fresh food light switch 5 times within 6 seconds and it will not go into defrost. What can be the problem? I don't know if I wired something wrong because I do not have the instruction sheet wh
Hi\015\012\015\012If the refrigerator is not defrosting automatically few things are to be examined. Defrost timer, defrost heater and defrost thermostat….\015\012Please check the bellow link to have an idea to your problem&h ...
Frigidaire GLHS36EESB Side by Side Refrigerator
Can I order a replacement door gasket for my Sub Zero 532 and fix it myself or do I need a technician? Where can I find DYI instructions to replace the door gasket?
I am a commercial refrigeration tech. not to familiar with the sub-zero. I have a friend with a 601F that is reading 00 tempature on the disply but the box is really about 28*f. Also the vacuum condenser light is on. Is there a temp sensor that needs replacing or the whole control board? Also is the vacuum condenser light related?
This is the correct reading but the temperature is displayed in degrees Celsius..and thats why the reading is 00 and the temperature is 28F to be able to set it right ...I will link you a tab with the converting from C in F ...
Hi, we just replaced our control (Jazz) board on our Admiral Fridge Freezer (not sure if Admiral is just a Maytag brand for the UK market).
We got the usual 00's when we switched it on and followed the instructions meticulously as follows:
Press light button and hold > Press Freezer Down 3 times > Depress light > Press Freezer down once more > Enter your code > Hold the freezer down button until it the digits flash.
Everything goes according to plan until the very last part. We hold th
Hello Steve,\015\012\015\012I think for the most part you are going about this the right way...with perhaps one exception I suspect. On a lot of those control`s the issue with entering the code is mis-understood. If it indica ...
I have a sub zero model 532 and the freezer does not work. I have turned the defrost timer to reset. I have also removed the control and checked find with ohm meter switch is recognized when switching off and on. I have 0 volts to relay overload. The lights in the freezer work and if I set the defrost timer on the fan inside freezer works. I suspect that the defrost timer is still defective.
We ll see how u need to check the defrost timer....Before testing the defrost timer, unplug the freezer to avoid an electrical shock hazard.A mechanical defrost timer controls the defrost cycle of the appliance. In older models, the ...
Sub-Zero 30.1 cu. ft. Cabinet Depth Side-by-Side Refrigerator 632 / F
I need to replace light bulbs in my Sub Zero refrigerator. I cannot remove the light shield. There appear to be no clips on the back of the shield. Running my hands under the back of the shield, I can feel only what appears to be a fan? The mounting slots are there on each side of the shield, but can find no clips at the back. What to do?
Sub-Zero 650 / O Bottom Freezer Refrigerator
I have a Samsung RB1855SW refrigerator. It is beeping as though the door is open, which it is not. The top (fridge) section light does not come on and it is cooling to 60 degrees. The freezer section is fine. Does this indicate a problem with the switch or sensor and if so would replacing it solve the problem? Is this something that can be done by a handy husband or do I need a repairmen? Please advise and include part number.
Hi\015\012\015\012\015\012Thanks for using FixYa. The Door Open Alarm goes off when the sensor senses that the door remains open for 2 minutes, there are 10\015\012times beeps.If the doors continue to remain open ...
Hi, I need to replace the door Seal/gasket on my Sub zero 680 refregerator. Where can I buy the seal/gasket? Where can I find the instruction to do it myself?
Sub-Zero 680 / F
I am trying to replace the door light switch in my Sub Zero 511. It's the square type. I don't think I'll have a problem putting the new one in, however I can seem to get the old one out first.
Sub-Zero 680 / F
I have a model ED5CHQXKT00 and want to replace the water and ice dispenser arms.
I think the part number I need are PS329462 and PS329466 because our refrigerator is "bisquit" in
color. Are these the right part numbers?
Do I need any other parts to replace these?
Do you provide instructions with the parts so I can do this myself?
Patrick L (Pat Vaske
Here is a link to all replaceable parts that you can order for this refrigerator.http://www.repairclinic.com/Appliance-Parts? ...
I JUST INSTALLEDAN ICE DOOR TO A SIDE JENN-AIR REFRIDGERATOR MODEL NBR JSD2789HES. THE DOOR WILL NOT OPEN TO DISPENSE THE ICE. IS THERE A SWITCH THAT NEEDS TO BE REPLACED OR DO I NEED A REPAIR PERSON??
THE PART NBRL I REPLACED WAS PURCHASED FROM EASY APPLIANCE PARTS AND THE PART NBR WAS WPL 61005883.
HOW MANY $10'S WILL IT TAKE TO GET AN ANSWER??
There is a solenoid, and a connector that can cause the problem.Check first that is not an installation problem. Ensure that the bracket that moves the ice door had been re assembled, or the door won't open, and you only hear the s ...
Jenn-Air JSD2789GES Side by Side Refrigerator