Sorry to hear about your problem. Sounds like you have a defrost issue. Hence your unit is not defrosting. All of this apply's if your freezer side has ice on it. If not. you have other issues
Here is a list of some things that can go wrong.
1. Defective heat coil
2. Defective defrost timer
3. Defective defrost sensor
You should call a service company to resolve your issue.
Since I tried to help you, Please help me and Rate/Vote on the response. Thanks
Suggested Questions/Answers :
It is recommended you read all this kind of situations
My frig. is not cooling in upper areas of both compartments. I can here the compressor kick on, I cleaned all debris from condensor, its fan motor is working, but removed the panel on freezer side and noticed evaporator looking icy, also the evaporator fan hasn't kicked on. Do I need to replace both evaporator fan motor & t-stat. Or do i have other issues? Also, the damper is making a little noise like its trying to click on, dont know if thats normal. Please let me know if you have any solutio
Sorry to hear about your problem. Sounds like you have a defrost issue. Hence your unit is not defrosting. All of this apply's if your freezer side has ice on it. If not. you have other issuesHere is a list of some things that can go wrong. ...
GE refrigerator Model No. GBS22KBSAWW A relay on the control board was clicking and the evaporator fan would try to start with each click. With the evaporator fan disconected the compressor runs, etc. I replaced the evaporator fan motor, and before I installed it, I pluged it in and the motor turned, but when I put the fan blade on, it would not turn, like the old one. Also, the condensor fan does not turn, but does not make the control board click.
This normally could be a bad start relay and over load for the compressor, dirty condenser coils need cleaning, condenser fan motor is not running or the compressor itself. The Relay needs to be replaced and checked.But if the problem is sa ...
Hi, I have a Samsung side by side refrigerator, mod# RS255BASB. How much voltage should I read (dc) for the evaporator fan motor. Also, how much resistance should the evaporator fan motor have? There are three terminals, on on the top and two on the bottom. Thank you.
Hello I tried to find the resistance of the windings but its noware to find. but you should have 8-12 volts dc at the motor.check to see it you have voltage when the fan should run. it wont come on with the compressor iot takes a couple seconds also ...
The cooling side is not cooling. But when I take it a part I can feel the cold air coming out of the condenser, and the evaporator fan is not running, therefore I am assuming the fan is not working. Is there any ways 4 me to check if the motor is still work? If I were to change the motor how am I to take out the fan's blade? Instead of using a nut at the end to secured the blade to the motor, they used something look like a little spring and I do not know how to take that little spring out. Any
Greetings,\015\012 The evaporator fan comes on after holding in the door switch for about 20-30 seconds. If you do not keep holding in the door switch. It will not start. If this is a sxs refrigerator. the defrost heater usually goes bad.. ...
Model GTS18DBMRWW Refrigerator. Smells like a burnt motor. Condenser running and fan next to condenser running. Smell is strong at top side, maybe evaporator fan. Is there anything else this could be?
I am repair most of everything I own, but never did a refrigerator. If it is the evaporator fan, I think I could change it out, but I want to know if there is anything else it could be. Thanks!
GE 18.2 Cu. Ft. Frost-Free Top-Mount Refrigerator - White-on-White
Migali f82at-------Only 30 volts are at the evaporator fan motor connections.... also the condensate pan heater burned up, would the fact that its (pan heater) not hooked up have anything to do with the fact that the fans are not working and the fact that the voltage is so low.... also is there supposed to be a thermal switch to activate the fans???
Migali Imperial RF82AT Stainless Steel
I worked on an old delfield freezer hat had r12 in it and the condensor fan and compressor would turn on when I plugged it in but the evaporator fan motor would not come on. I ran 120 vac to it and it ran, but the unit did not have a sqamatic and I really didn't know the real sequence of opperation to figure out why the fan would not come on for the evaporator. If you could find some thing on the model:6125-s or might be 5 with serial# 147697-T let me in
Some older models ran power throughthe door/ light switches, for the evaporator fan, or perhaps even ewired through the defrost thermostat( reason for that is if evap is warm no need to run a fan and circulate hot air through the cabinet did you try ...
HORRIBLE NOISE I have a GE Gss22jf we had a repair guy come over to look at it because it is really noisy, he said it needs an Evaporator Motor, an ADC Controller and a defrost element at approx $800 this sounds expensive, can I buy the parts online and fix it myself? the only parts I found that sound like these are an evaporator fan motor, a defrost heater element, and the ADC Controller, how will I know if I am buying the right parts? any suggested sites for purchasing these?
Just replace evaporator fan motor and fan blade, should take care of it. $60.00 ...
GE GSS22JFMWW Side by Side Refrigerator
Need to replace the fan motor on a Samsung RS2530BWP/XAA.
Its the fan that blows on the compressor and also sucks air thru the coils.
How does the fan shroud attatch to the evaporator pan, I dont want to break anything. Please help.
Evaporator fan making noise
Can I order one and replace it?
Also, unit came with wrong light bulbs which melted control unit. Sears fixed it, but required that we buy the 250 dollar warranty or pay 250 for the service. Warranty now past with new issue. Am defrosting unit in case Ice is on the fan first, but want to know if I can but the part if I ned to. Appears held into place with one screw at back of freezer.
You can remove and replace this part; just secure that this is the correct replacement part require. Find this part HEREAnd ...
Kenmore 24.8 cu. ft. TRIO Bottom Freezer Refrigerator
I have a GE Top Freezing Refrigerator. The model is GTS12BBMBRWW, if that helps. The refrigerator is constantly leaking. This is because ice constantly accumulates on the top wall of the refrigerator and then slightly melts and drips water into the refrigerator. Also, the fan (or maybe some sort of motor) in the top left of the refrigerator is obviously working really hard and makes a really loud buzzing type sound. These problems started at the same time so I know they are connected.
The drainhole for the defrost water is frozen . When this happens , sometimes the excess water , flows to where the fan is , makeing a rapid clicking noise , or stopping the fan completely . Also , could be the glass defrost heater is busted , not le ...
I have a roadpro snackmaster deluxe and it will not turn on even in a known good outlet. i have tested 4 different ac outlets in my truck and still nothing. i have cleaned the fans and i have also been told that since it got to about 9 degrees that the motor could have frozen over but i do not know what i can do to fix it.
Kenmore refrigerator model 53552200 evaporator fan motor won't shut off since I had the unit unplugged to clean the condenser coil. It's been 2 days now, and I don't know if it has gone through a defrost cycle or not.
Good day,\015\012First step is to check the condenser fan motor to make sure it is running. It is not unusual to dislodge something causing that motor to not be able to run after cleaning. In some cases one of the blades of the ...
NEW HIGH SPEED EVAPORATOR FAN MOTOR TOO LOUD Repair technician told me there were problems with the original evaporator motor and replaced it with a new high speed one. Now the fridge is too loud. Before it was quiet. Now with the new motor there is a high pitched louder sound that is very irritating and can be heard all over the kitchen. The original fan and the electronic controller blew because of a large buildup of static electricity on me which blew these components when I touched the refri
It's the rotors making the noise not the motors! I replaced the motor, still made noise, I took off rotor blade sanded it down around each blade, no more high pitched hum! ...
Frigidaire FRS26H5AS Side by Side Refrigerator
Model psc23sgpass GE Profile freezer and frig do not get cold enough. I have already cleaned the condenser and defrosted the freezer. We seem to have determined the evap dc fan motor is not running. But I have purchase new and tried it and it also seem to not run. Is there a check I can do on the fan motor to confirm the original is bad. Also what else may prevent this from running when called for.
The fan is controlled thru the main control board located on the back of your refrigerator. Pull unit away from the wall and you will see a metal plate. The board is located there and you will need to replace the board. This is a common problem with ...
GE Profile 23.3 Cu. Ft. Counter-Depth Side-by-Side Refrigerator - Stainless-Steel
I have a GE refrig. model GTS22ZCMARCC. The evaporator fan has been pulsing up and down forever. Then the freezer stopped getting cold and the refrig. part was not as cold. I check the evaporator fan and it was not running but the evaporator coil was cold and the compressor was running continuos. I replaced the fan motor and it still does not run (same problem). Is the only other thing that could be causing the problem be the control board on the back of the refrig. (AP4436216)?? Thanks, Ri
It's the board,also change out the sensor that's on top of the coil,it looks like a white bullet,the part number for the temp. sensor is wr55x10025 and the board is WR55X10942.everything runs through the board,i've seen when you call for water the co ...
GE GTS18SHPBS Top Freezer Refrigerator
Kitchenaide side by side, model # ksra25fk---freezer too cold (-10 to -15) & fridge side sometimes gets above 48 setting of the "overtemp" alarm. I ran the internal diagnostics test and everything checks out ok except during the air baffle test the baffles open and close, but the evaporator fan does not run. However, the evaporator fan runs during test 03 for the evaporator fan motor. I dismantled the back panel of the freezer--there is no frost buildup and the defrost coil heats properly. Both
You said it yourself, the 'air door' or baffles as you called them aren't not opening up to let some air out of the freezer, into the fridge. That's why the freezer sis so cold and the fridge is warm. The door is controlled by a thermistor. You will ...
Posted on Jan 29, 2010 KSSC48QMS01 control lights flashing with beeping sound. Solution # 1: Main control board is over temperature. Look for blocked condenser air flow or inoperative condenser fan motor. Refrigerator over 48°F or freezer over 15°F for 3 hours. Run diagnostics and test operation of all components. Both thermistors failed. Run diagnostics and test thermistors and thermistor leads. No feedback from evaporator fan motor. Run diagnostics and test fan motor and/or wiring. UPDATE: Che
KitchenAid KSSC48QMS Side by Side Refrigerator
Ge side by side refrigerator........the fridge stopped working, there
is power...i removed the bottom back panel and the fan that cools
the compressor was making a clicking noise and the fan blade
was barely moving (kinda like a clock ticking)....i thought it was
probably the motor..... i disconnected the wired plug that goes from
the motor to (i think) the compressor, then i reconnected and the
motor (and fan) and the compressor kicked on and began to run
normally........this also happe
Hi!!\015\012\015\012Make sure the condenser coil in front of the fan is clean. Also, make sure the fan is working strong, not just barely moving. The whole area can be cleaned using a vacuum with a brush adapter. When doing the condenser coil ...
GE (PSS26MSRSS) Side by Side Refrigerator
Display showed ER FF, freezer fan was not running, but ice fan was. I Pulled the freezer fan (there was no ice blocking it), I checked it with another 12v source and it did not spin. Then I checked the ice fan with a 12v source, it also didn't spin. When I put the ice fan back in, it wouldn't spin anymore and now I'm getting ER IF. Is it possible I blew out that motor while testing it and now both are shot? Also, I've had a lot of problems with frost and read that there is an upgraded mothe
Call LG customer service for your options. ...
LG LFX25960 Bottom Freezer French Door Refrigerator
#GLHS35E4SB6 Frigidaire side by side. evaporator motor area becomes extremely noisy and eventually shuts off. The fan could be floating on the motor shaft and engaging the shroud. Apparently the motor has a thermal switch that turns off the motor. Disconnecting unit then reapplying power later it works for a period of time then it starts all of again. A repair man has replaced both the motor and the fan twice and within a couple of weeks the problem reoccurs. The unit is only 1 1/2 yea
Be sure maybe the sound coming from evaporator fan some times it accumulate ice near it do not open for long time both doors or put hot things inside the fridge or freezer . ...
Frigidaire Gallery Series GLHS269ZDB 36" 26.0 Cu. Ft. Side-by-Side Refrigerator w/ 7 Button Dispense...
I have a Samsang Cooltech fridge model number SR385NTS. The cross flow fan at the back of the fridge has stopped moving, the motor is trying to turn the fan blade but is unable to, it sounds like the thread connecting the blade to the motor is stripped. The fridge makes quite a loud noise when trying to turn the fan. The fridge also seems to be very cold even when set to a moderate setting Is there anywhere I can get a repair manual or a diagram on how to remove the panel surrounding the fan so
On a refrigerator, the compressor and condenser fan motor are operating. The evaporator fan motor is not operating. The motor has 120 volts. Is the motor failed?
Hi,\015\012Yes, you need to look for a new motor. If you have power to the motor and it is not run then it needs to be replaced. If it is tight and does not turn freely then you may be able to free it up by working some WD-40 into the bearings ...