Suggested Questions/Answers :
It is recommended you read all this kind of situations
I have a GE side by side refrig/freeze (model GSC23KGTE BB). The refrig door handle is coming loose. I can see the threads of the bolts, so there must be a nut inside the door that all I have to do is tighten. How do I get inside the door to do this?
Hi. The water flow is very slight. I have changed the filter to no avail. I have well water and suspect that something might be clogged or there must be a pump someplace? The water flow into back thru the tubeing is good. Disconnected the water line above the door and the flow is slight, so the clog must be located between the filter and that point above the door-left side. I see there is an access panel below the filter on the back wall inside the refridge. Clog must be in there someplace? Than
You\015\012have two points where you can check the dispenser water. At the rear where the\015\012water supply comes in is the water inlet valve. If you disconnect the dispenser\015\012water line and then see how fast the water comes out w ...
Whirlpool Gold GS6NBEXRL00 Stainless Steel side-by-side-- The ice dispenser motor will not dispense ice from the refrigerator after pressing the dispensing lever. It did dispense occasionally if I would tap the door but now it doesn't do anything. I am out of warranty period so any simple repair I must do myself. By previously tapping the door to get the motor to work makes me believe that there is a short in the wiring somewhere inside the door (harness, connectors, boards, etc...). I have thou
Hi,\015\012 \015\012Thanks for contacting Fixya.com.\015\012Evaporator may need to be cleaned with a nickel safe - phosphoric and /or citric acid cleaner. Scale build-up on evaporator fro ...
I have a ksbp25fkss side by side fridge and the door handle on the freezer is loose, but the handle is not the one depicted in the manuel. the handle must be tightened from the back or inside of the door. How do I get at it??
You should have trim below and above the handle if not then and its a stainless steel door then there is small round opening on the side of the handle you'll need allen wrenches once you loosen the allen the handle slides up or down then you will be ...
KitchenAid KSCS25FKSS Side by Side Refrigerator
2006 GE Profile PSF26NGTD CC Side by Side Refrigerator. Water dispenser works but cubed and crushed ice dispenser will not work every time, no noise or any other out of the ordinary occurence. All lights on panel are steady, none flashing. Have tried removing tray from freezer, turning ice maker on and off and gently pushing lever up inside of ice dispesing mechanism in freezer. Problem must be in signaling device from door front to ice dispenser????
Your water line must be freezing up. Take a hair dryer & defrost the water line. ...
GE GSS25LGM Side by Side Refrigerator
Loud vibration coming from under freezer side. Filter is broken off inside of filter casing. Replacing remainder of broken filter and applying pressure does not change vibration. Suspicious of something else - broken filter just a side thing. It has been moved to a new location and could have been damaged. No manuals online. Any assistance on nuts and bolts to check on the underside to verify there are no loose parts or missing screws? Whatever runs under there runs for a few minutes then the vi
Check to see if the fan blade has been bent or damaged ...
Whirlpool GS5SHAXN Side by Side Refrigerator
Trio, model # 795.75546401 problem with right side door latch (the part that interacts with part 406D, "door holder"). Right side door latch is broken or loose, door must be manually pushed back after
I took two bolts on top of the door'fridge out now how I put its back in the nuts inside
The nuts should be stuck in position or welded in position but if they have broke free all you can do is hope for the best on lining up the bolts or install new swrews into the metal of the fridge. ...
The freezer side of my fridge/side by side is working fine and the fan is blowing cold air. but, the other side is not cold anymore just slightly cool,even with the thermostst turned up all the way. i found a small door behind a cover in the upper left fridge inside with a small actuator motor attached to it. it goes through to the frezer side. i opened that door to let the freezer side air in. but after a while the door closes automatically.
could this be the thermostat or is it stuck in d
Hello,it's your compressor that is the cause of it not blowing.all you need to do is to get a new one and also get your fan serviced.take care. ...
GE GSS20IEPWW / GSS20IEPCC Side by Side Refrigerator
I have a kenmore top freezer refrigerator model 253 about 1 1/2 years old. The fridge door sticks at the bottom of the door and the bottom of the fridge inside. There are scratches on the fridge bottom from the door rubbing on it. The door must be pushed shut every time. The fridge levelers have been adjusted to allow the door to swing closed on its own but will not shut completely because the door bottom contacts the fridge inside bottom. Is there some way to adjust the door? I do not see
I had the problem my self :)you need to take the freezer door out then the fridg door and add small ring like 1mm to the hinges of the fridg door poot all back and see if it rais the door a bit....what i did is on the top of the freezer t ...
Kenmore 20.6 cu. ft. Top Freezer Refrigerator
I bought my Samsung french door refrigerator(RF267AERS) about one month ago(July, 2011). I noticed two days ago some frost and ice build up on the inside left side of the freezer drawer(no problem with the right side). I did not leave the freezer open for any extended time and gasket seal on the inside of door looks okay. It's a new refrigerator and I keep everything very clean in my home. Why is this happening? what's causing this and what is the proper solution? can you help?
Samsung RF265AA Bottom Freezer French Door Refrigerator
Molding inside door on freezer is very warm to the touch. Almost hot. Model TFX27EKC
(21 YRS OLD) Freezer side seems to be working, but systme check on door, gives code FF. Refrigerator seems to be working, and freezer does too, except for the molding on the inside of freezer side is very warm. Is there a relay for a defrost coil that maybe stuck closed, causing the defrost coil to be turned on all the time?
Hi WR,Your symptoms scream "failed condenser fan motor!". This old unit is definitely worth the repair (one of the last of the great GE's). Here's the thing, the fan motor for your fridge calls for a #WR60X187 and this one runs about $110 ...
GE (PSS26MSRSS) Side by Side Refrigerator
Refrigerator top freezer door slightly rubs to inside freezer bottom while closing the door that opens on right side. Due to this after closing the freezer door, the door opens less than a mm near the left gasket and humid air gets inside the freezer to form ice. Is there any adjustment on the top hinge to bring the freezer door up by about 2mm (1/16 to less than 1/8"? It seems the freezer door has dropped slightly from the factory setting. In my judgement, there is enoug room on the top of the
I think I can help. Usuly the doors have been swapped around in this case. look closely at the freezer door on hinge side. there should be a small metal piece that covers the hinge to prevent anything from jamming hinge. thi ...
Whirlpool ET1FHMXLQ / ET1FHMXLT Top Freezer Refrigerator
Maytag Side by Side Model RSD 2200. Problem with closure of refrigerator door. Unlike the Freezer Door which closes without effort and operates as if "spring loaded" over the last few inches of travel, the refrigerator door must be pushed all the way to the full closed position. Nothing appears to be damaged or interfering with the door. can you help?
SxS refrigerators have what are called ride-ups. One half of this assembly is riveted to the door hinge the other half is screwed to the bottom of the door. It is usually best to replace both parts at the same time. Both fridge and fre ...
The freezer door on our GE side by side fridge does not shut tightly in the center of the door causing a frost and ice build-up on the outside of the door, ( in the inside edges. We have been told that either the door or the center bracket in the unit is warped. The fridage is seven years old.
Is this a realistic diagnosis?
There are ways to adjust the hinges, and loosening the screws on the plastic door liner will allow you to "warp" to door a little bit in an effort to get it to line up flat and square to the opening. Sometimes the gasket gets folded up on the hinge s ...
I have Samsung RS25445SH side by side refrigeratorl. We purchased January 2006 and never had problems till now. Water is slowly leaking from both sides in the front at the bottom underneath, near the white door height adjusters and also water is pooling in small amounts, but enough that I have to sop it up every so often, inside the fridge side on the white bottom in the corner. No leaking behind or anywhere else inside fridge. The leaking is enough that unchecked runs all over the kitchen f
Samsung RS2630SH Side by Side Refrigerator
The front side of the vertical divider (inside the door) in the side-by-side is VERY hot, nearly hot enough that you can't keep a finger on it. Inside of fridge and freezer are still cold and frozen. I suspect it's the cooling fan in the bottom/back, which has been squeaking some due to a bad bearing; that problem had been fixed, to this point, with some WD-40. I haven't pulled the unit out yet to look, but was curious if anybody had seen this before.
Hi,\012Here is a tip that I wrote about\012the reasons why the sides and/or seals could be getting hot on your\012refrigerator.Refrigerator\012Tro ...
Samsung RS2630SH Side by Side Refrigerator
Kenmore side by side refrigerator leaking at elbow joint on freezer side door. This joint connects tube from back of fridge to a tube that runs up the inside of the door. Any trick to getting elbow joint off without mangeling the tubes? Any ideas as to the cause?
Hello, This connection is what they call a pushfit connection...The way to get um off without mangling the tube is press down on the lip at the edge hard and pull the tube at the same time...should slide right out. These fittings do tend to start lea ...
Amanda afd2535deq loose left side handle on bottom freezer door.
inside of freezer on the door there are two screws that are holding a support, but, under the support on the back door panel itself are two additional phillip head screws. if these two screws are taken off the back inside panel would that able the back panel to be removed and thus exposing the handle screws???
Mike,\015\012\015\012I would give you an idea for making sure what the screws are for without doing things you cant undo later. \015\012\015\012What you do is loosen on of these screws and check the handle. If the handle has started movin ...
Amana Easy Reach AFD2535DE Bottom Freezer Refrigerator
I have a side by side and my water line is leaking from inside the door how can i take it off and find out about the water line in side the door.
This may be bcoz of the rusting of the tube or there may be hole in a tube...this bcoz of the water that comes out the pipe often...since freons are reacting it will easily leads to rusting of the tube...plz call u r service provider for u r fridge.. ...
Door Removal trying to move new side by side with bottom freezer ( Samsung ) and doors need to be removed to fit inside house. How do you remove the doors ?
If you don't have the manual, go to Samsung's website and download the manual. It explains how to remove and adjust the doors and bottom drawer. ...
Samsung RF265AA Bottom Freezer French Door Refrigerator
I have a ge side by side model gss25qgmd bb. the water dispenser is not working. I have narrowed the trouble to the tube which enters the bottom of the freezer door and ends at the spigot in the door. I have hit it with 100psi in both directions and the "clog" won"t budge. How can I get inside the door without destroying it so I can fix or replace the hose?
I had the same problem. My fix was to disconnect the tube as it enters at the bottom of the freezer door and allow room tempurature( to warm the inside of the tube) and melt the ice in the tube. It took about an hour or so and it worked.\015\0 ...