Suggested Questions/Answers :
It is recommended you read all this kind of situations
Re: Kenmore Top Freezer formed ice, main refrigerator area is not cooling Kenmore Top Freezer (Main refrigerator area) is not cooling; This trouble shooting has happened for the past year. Main refrigerator area was either too warm or too cold and now, is not cooling period. A ***** of ice has formed in rear of the ice box. I removed ice maker and rear panel. Behind the panel was the unit/part that houses the refrigerant inside the aluminum piping and louvers. Ice was caked on throughout it.
Not easy to diagnose. the basic fault is that the defrost system has packed up.check that there is continuity thro the defrost heater. there may also be a thermal fuse in series with the heater so check that also.if those ok, ...
Kenmore 18.3 cu. ft. Top Freezer Refrigerator w/Through-the-Door Water Dispenser
Kenmore refrigerator 71203100 ice maker does not make ice. I get water from the water dispenser inside the refrigerator, but no water in the ice maker. The metal bar used to turn the ice maker on and off is intact and set to the position to make ice.
The water inlet switch on the back lower is always the problem. It has 2 solenoids, 1 for water and 1 for ice. They never go out at the same time. Follow the water line to the frige and there it is. Turn the water off repalace the part and plug the f ...
Kenmore Refrigerator I replaced my ice maker with a new Ice maker from sears. It does not seen to be working. Is there a way to test the Ice maker and is it on some kind of timer so the water will drop in the ice maker to freeze. I want to try and cycle the ice maker to verify its working. It is the correct ice maker and it hooked up just like my old one. It had the same wiring harness as the old one and match up perfect.
It has to cool down to 17 degrees f to start a cycle and will take another hour plus to make the first set of cubes\015\012\015\012if it had already been this long \015\012is there water in the ice maker\015\012if so check the ...
Kenmore Model number 74254
Had water building up in the refrigerator section, saw a post that said to defrost it and add copper wire to drain port. Did this and it seemed to be working fine for a few days (ice maker working). Later noticed a lot of water on the floor. Looked in the evaporator tray and it was full of water. Noticed water in the refrigerator, ice on the bottom of freezer and ice maker making hollow ice cubes. I was going to empty the evaporator tray when the water to the i
Good day,\015\012First, you should remove the ice maker, and make sure the fill tube from the back of the machine feeding the back of the ice maker is in place and is not broken. \015\012This tube could ...
Kenmore Elite 795.77573600
Error "error if" appeared on display panel. I believe this is related to the ice maker fan. Unplugged freezer and turned ice maker off. Turned refrig. on, and error message does not come back. Error message reappears within 5 minutes if I turn ice maker back on.
Refrig has been working without ice maker turned on for several weeks; however, the freezer has alot ice built up on the top and back of freezer.
Do I need part number 1463582 (dc
The freezer ice is probably building up because of a 'defrost cycle' issue. I have looked up the 'if' code for your machine. There is no mention of that fault. It is an LG right? Made for Kenmore. I have a service manual that is close, but not that s ...
Refrigerator- Kenmore Elite 795.77573600 Error "error if" appeared on display panel. I believe this is related to the ice maker fan. Unplugged freezer and turned ice maker off. Turned refrig. on, and error message does not come back. Error message reappears within 5 minutes if I turn ice maker back on. Refrig has been working without ice maker turned on for several weeks; however, the freezer has alot ice built up on the top and back of freezer. Do I need part number 1463582 (d
This error you are getting is coming from an issue with the fan you may call it freezer fan or evaporator fan, you stated that you change it however it still give you the same error that relate to the fan…first make sure when you connected all ...
I have a Kenmore Model 795 refrigerator with an ice maker in the bottom drawer. We purchased the refrigerator in August of 2008 (currently November of 2010) and finally hooked up the ice maker last week. (November 2010)
Question: The ice has a weak chlorine taste to it. Is there an in-line filter that I can replace? Or, should I install an in-line filter?
The 795 model you make reference to only tells me that this is and LG bottom mount Refrigerator. There are several numbers missing from the model number. This is and example of a good part number: ...
Why does my ice maker not get cold enough to produce ice? I have a Samsung RFG297AAWP French Door refrigerator that I just bought and installed May 9th. Everything is functioning except for the ice maker. Water is getting into the ice maker but it never freezes the water. I can tell by feeling inside that it isn't getting cold at all. The fridge temp is set at 40 degrees and the freezer is at 0 degrees. I have even tried 38 and -4 with the power freeze mode on. Still no ice. When I depress
Samsung RFG297HDRS Stainless Steel
I have a Kenmore Elite Trio model 795.77563600 that has the ice maker in the refrigerator door. The ice maker has been working fine for quite some time. All of a sudden it stopped making ice. The water dispense on the door continues to deliver water. I am not able to move the automatic swing arm. What may be the problem? Can I remove the ice maker and take to a repair shop? If so what are the steps for removal?
Kenmore 73502 / 73504 / 73509 Bottom Freezer Refrigerator
Hello. I have a Kenmore Elite side by side refrigerator, model# 106.50502990. It was manufactured in March of 2000. The ice make broke and I need a replacement. The ice maker part# I got is 4317943. However, this unit has a 4-pin flat connector and the original ice maker had a 6-pin flat connector and as a result I can't plug the replacement in. Could you tell me the correct ice maker part number that I should order?
4317943,i looked it up it says that this is the ice maker for your machine,do you know that it comes with different harnesses,or take off the old harness and put it on the new ice maker,it does have 4 wires on each harness,i just called sears for you ...
Kenmore Refrigerator I have a Kenmore side by side refrigerator freezer. It has a water and ice dispenser in the door i am geting water to the water dispenser but not the ice maker. Can you help me? Gary
Check the mirco-switches behind the panel at the dispenser section. basically, when you depress the lever for water or ice, those levers make contact with a switch, and the switch turns on the ice dispenser motor. if the lever is pushed too hard, t ...
Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
KENMORE REFRIGERATOR HAVE 12-15 YEAR OLD KENMORE REFRIGERATOR WITH ICE MAKER THAT GETS WATER SUPPLY, FREEZES WATER AND THEN
THAWS THE WATER BUT DOESN'T DUMP THE FROZEN ICE CUBES INTO TRAY
Need a model # ... mostly likey better to just replace ice maker if that old.. 12-15 if same age as ref. ...
Kenmore 73952 / 73954 / 73959 Top Freezer Refrigerator
I have a Kenmore refrigerator model 795.73264300 and I've been told by a service tech that I need a freezer fan motor replaced along with the ice maker. Total cost is about $400. I've been on line and found the correct fan motor for under $50 and don't care about replacing the ice maker at this point. The trouble is I'm not sure how to get to the motor. Can you provide instructions for removing the ice maker and plastic panels in the freezer compartment needed to replace the motor.
Go here:\015\012http://www.searspartsdirect.com/partsdirect/part-model/Ke ...
Kenmore elite model 596.76592600. 3 days ago ice maker did not work, installed a new water filter yesterday and ice maker started working several hours later. Last night the water dispenser stopped working and no water coming out today. The ice maker is working perfectly......but no water coming out of the dispenser inside the refrigerator. new water filter is 24 hours old...what could be causing this problem??
Kenmore Elite 22.4 cu. ft. Bottom Freezer Refrigerator with Adjusta Cube Ice Maker
I have a older Kenmore refrigerator I use just for overflow, to cool pop etc. When I put it to secondary use, I removed the ice maker. Since the defrost timer was part of the ice maker, I installed a defrost timer that plugged in to where the ice maker used to. It has been working great for some time.
When I discovered recently it was not cooling and the compressor was not kicking in, I first checked the defrost timer.
When I move the adjustment and hit the groove, it shuts off and when I tu
Hello,Welcome to FixYa.I suspect by your description the fridge indeed has a seized/lo ...
I have a Kenmore SS refrigerator 106.55522400. My ice maker stopped working. I replace control module on ice maker, wire harness with built in fuse. My question is how much voltage should I see on the wire harness connected to the control module. There is a green, brown, black and white. My measurement on the black and white is 35 volts. I disconnected from wire harness that enters side of freezer and also read 35 volts. My ice maker is still not working so I am wondering would it be the power m
Kenmore top mount refrigerator, my water dispenser is sluggish and the ice maker is not making ice- I replaced the filter and heated the ice maker, what could be the problem?
Kenmore refrigerator 253.53612300 ice maker works & dispenses cubed ice, but the ice crusher doesn't work. Was working fine one day, next morning , nothing. It doesn't make any noise, if I choose crushed ice it just dispenses cubed. I haven't tried anything yet, we had alot of relatives staying with us for my son's wedding so I thought maybe a switch got burnt out with the use. I have fixed other refrigerators and freezers before out of necessity, but haven't ever worked on an ice maker/crusher
Kenmore Elite top freezer refrigerator model number 106,73206300. Refrigerator barely cools. Freezer barely keeping food frozen even with cooling on max. Ice maker very slowly producing ice. Outside of refrigerator is warm. Some air circulating in freezer, litter or no air circulating inside refrigerator. Thanks
If there is cooling and\015\012defrosting problem in your fridge. Also over cooling or not getting cooling\015\012properly problem. Then the problem relates to thermostat.\015\012\015\012The proc ...
Model #795.7757. Kenmore Elite Trio. Ice forms around the inside of the ice maker door. It freezes shut and you cannot open the door. Water freezes around the inside of door somehow and freezes the door shut and you cannot access the ice bin inside.
There is also condensation that forms above the ice maker on the roof of the refrigerator when the door is shut.
First thing to do is grab a hair dryer and defrost all the ice. Following this you would look at the rear of the actual icemaker to assure that when the water is coming into the unit that it is going into the icemaker tray and not overfilling the tra ...
Have a kenmore refrigerator model # 106.56563400 . problem is the ice maker is not dispensing water into the ice maker to make ice. i have switched the wires on the water valves for the door water and icemaker and hit the door water button ice tray filled with water but thats as far as i got. any help would be great
Kenmore 56549 / 56542 / 56544 / 56546 Side by Side Refrigerator
Kenmore side by side refrigerator 10658169702 ice maker cubed ice dispensor works, the crushed ice does not work. When I change it to crushed there is no noise at all. The auger coupling rotates when it is on cubed but it is not moving when on crushed. I believe the ice maker model # is 2212384 What should I do ?
Sounds like problem is in display activatin switch check plug under hinge cover at top of freezer door otherwise new diplay panel needed ...
New (3 days old) Kenmore Elite refrigerator model 795.7103 with ice maker. Water supply line to the ice maker immediately froze up so won't fill tray to make ice. Serviceman came out and melted ice blockage in line which allowed flow (injected warm water into line). He told us to keep fridge temp at 38 or higher. With setting at 39 the line froze again. Do we keep messing with this - is there a solution that doesn't involve repeatedly thawing out the water line? Or do we tell them to take
First of all, your freezer should be much lower than 38 degrees. For the ice maker to even work proplerly it has to be below 10 F. Some models have a heater that goes around the fill tube to keep that from happening, but in my opinion, if its only th ...