Suggested Questions/Answers :
It is recommended you read all this kind of situations
I just replaced the icemaker in my Kenmore Refrigerator with the WR30X10093 Kit that fits many other models of refrigerators also. The water slightly overfills the ice tray and freezes the cubes together in the dump tray. Is there an adjustment to correct the amount of water to fill the tray or how do I adjust the WR30X10093 ice maker to prevent this?
Congratulations, you have very good water pressure. I am not aware of any adjustment for the time the fill solenoid opens. The easiest thing I can suggest is to adjust the water flow with the supply valve. If you have the typical saddle valve, it has ...
Ice Maker in Kenmore Elite 106.55603400 isn't working.
I turned off the fridge, left the freezer open (to thaw out the parts, I was thinking the maker itself froze because there's ice in the maker but it doesn't pop them out into the tray), and it made some ice. It isn't consistent though. The last few events were:
no ice for a week
turned down temp, 10 cubes
no ice for a week
turned off fridge, 10 cubes
no ice again
What do you guys think?
Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
I have a Liebherr 3066 small integrated fridge with an icemaker. The icemaker was working fine, but now dispenses water in the ice cube collection tray and then makes some ice as well and dispenses them in the tray with the water. the water then friezes and the ice cubes stick together in a giant ice cube mess. does anyone know what is going on?
I have a 1993 Kenmore 21 Refrigerator, model # 106.9731680. The icemaker is not working. When I first looked at the icemaker I noticed that the ejector blades were stuck in the ice at about the 4:00 o'clock position and that the ice was very high in the [email protected] assembly tray. Also noticed that the ice tray had about a half an inch of frozzen water with ice cubes inbeded in it(the ice cubes were stuck together at the top in groups of four or more).
I toke off the [email protected] assembly t
IMO, your problem is the solenoid that controls the flow of water to the ice maker. This is a very common problem on a unit that is 16 years old. If you replace the solenoid your problem should be solved. ...
Kenmore Model number 74254
Had water building up in the refrigerator section, saw a post that said to defrost it and add copper wire to drain port. Did this and it seemed to be working fine for a few days (ice maker working). Later noticed a lot of water on the floor. Looked in the evaporator tray and it was full of water. Noticed water in the refrigerator, ice on the bottom of freezer and ice maker making hollow ice cubes. I was going to empty the evaporator tray when the water to the i
Good day,\015\012First, you should remove the ice maker, and make sure the fill tube from the back of the machine feeding the back of the ice maker is in place and is not broken. \015\012This tube could ...
Have a gs201eta ww refrigerator ice maker problem
Unit makes ice, light works and water dispenses from the door. However ice cubes and crushed iced does not dispense from the door. The dispenser motor seems to be frozen at normal temperatue, however if I defrost
the freezer the motor that turns the dispensen screw
seems to work OK and the crushed ice lever activates properly.
Also, the ice cubes are not separate but are lumped (frozen) together in the ice cube tray.
Also need to know
The fridge gets its cold air from the freezer through a vent\015\012between the freezer and fridge. the fan in the freezer blows air through\015\012it. there is a flap you adjust with the\015\012fridge temp. control.Make sur ...
Some water dripping down into ice cube catch tray every time ice maker fills -- results in large frozen mass inside ice cube tray after several days.
When this happens we remove the icemaker, remove the ice chute from the back of the icemaker (usually you twist the chute to get it off}, and we then silicone seal the chute and the top of the ice mold where the ice chute sits. You have to be carefu ...
Whirlpool GT2SHKXM Stainless Steel Top Freezer Refrigerator
I have a french door refrig with two ice makers. I cubes seem to be wet in door when crushing ice. Also in bottom ice maker the cubes are stuck together in tray in one clump. I lowered temp to -4 but it did not help. Bought in Lowes july 2010.
You need to check the door seal. If you place a $bill in the door it should have resistance all the way around as you pull the bill through. It may just be that the doors need adjustment.. If you are able to maintain -4, the ice maker heaters may no ...
Ice from ice maker sticking together. Is the temp in the freezer to high or to warm causing this?? The ice is just one big clump of ice cubes all stuck together!!
To warm or maybe staying in deforest to long if you don't have a good amount food in the freezer it will warm up in deforest and make ice to lump ...
My ice maker is crushing the ice despite the fact that I have it set on cube. I have dumped the ice out of the catch tray twice and made sure that the dispenser is not blocked, but it still continues to crush. I tried switching to the crush setting, and it crushed there too. I switched back to cube but it is still crushing the ice. Why is this happening and how can I fix it?
The bottom of the tray has a rod attached to it that controls a flapper that opens up to allow the ice to pass thru without hitting the cutter or crush blades. this rod goes into a housing at the back of the freezer that has a solenoid switch that ac ...
Frigidaire FRS3R5EMB Side by Side Refrigerator
The ice maker has been working fine, now all a sudden it stoped working. The other night the moter that kicks the ice cubes out was making a funny clicking noise, like something was hung up in the gears. Now the water dispenser isn't filling the tray. I've got the ice maker out, should i let everything thaw out and put it back together, and see what happens ?
Good day,\015\012Snap off front cover. If it has a white plastic gear with a SCREW in the middle, check the teeth in the gear. If stripped replace it with a new one. If it is the modular style, you'll have to replace the module or bet ...
Whirlpool 25.4 Cu. Ft. Side-by-Side Refrigerator w/Thru-the-Door Ice & Water - Satina Stainless-Look
Large mass of ice cubes frozen together in tray, most likely from leaky ice maker. Can this be fixed without purchasing a new ice maker.
Have you checked it when it's filling to see if it's overflowing or the heater on the ice maker might not be shutting off and melting some of the cubes but you have to check,also it could be the water valve,see if there's an adjustment on the ice mak ...
Whirlpool 21.0 cu. ft. Top Freezer Refrigerator with IceMagic Plus Ice Maker
Kenmore refrigerator i purchased a used kenmore and when i hooked it up i get nothing but water filling up the ice cube tray. do i need a new ice maker?
THE ICEMAKER HAS TO GET BELOW 32 DEGREES TO WORK RIGHT,IS THE FREEZER GETTING DOWN TO TEMP.?LET ME KNOW-MIKE ...
Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator
KENMORE REFRIGERATOR HAVE 12-15 YEAR OLD KENMORE REFRIGERATOR WITH ICE MAKER THAT GETS WATER SUPPLY, FREEZES WATER AND THEN
THAWS THE WATER BUT DOESN'T DUMP THE FROZEN ICE CUBES INTO TRAY
Need a model # ... mostly likey better to just replace ice maker if that old.. 12-15 if same age as ref. ...
Kenmore 73952 / 73954 / 73959 Top Freezer Refrigerator
My old whirlpool refrig. with frostless freezer on top model # ET20DKXSN 00 has started to form frost in the back of the freezer where the ice cube trays are stored. It seems to be coming from the around the cover where the ice maker would be attached if I had one. Any ideas what would fix the problem. In a few days it makes the big tray stick to the frost at the back.
Check the back of the refrigerwtor there shpoould be a opening where the water goe into the freezer for the ice maker. you need to seal it up so that the moiust air from outside does not enter the freezer. ...
The ice maker on my subzero 650 makes ice. But also seems to drip water that freezes all the ice together and build up frozen water. I suspect the water shut off is a problem. Or whatever monitors full ice cube tray before ice is dumped. Any advice to fix?
The water valve is under the freezer (near the left front wheel). I have exactly the same problem - I just leveled my unit better (I assumed that was the cause), but it still does it so now I guess it must either be some solenoid valve malfunction ...
Sub-Zero 650 / O Bottom Freezer Refrigerator
Whirlpool refrigerator Model # ETIRHMXKT 4163522
Water is leaking from back of freezer compartment and then freezing on floor of freezer compartment. Ice maker is only making partial ice cubes (not solid, water filled).
When they fall into ice tray they breakup and freeze into one massive ice slab. Also, water is leaking down the back side of refrigerator compartment and then freezing. I am catching the water in containers where it freezes.
Can be worn gaskets...clogged pipes or coolant leakage.tell me about ...
The ice maker in my samsung fridge is putting too much water into the ice tray thus dripping water into the ice compartment and freezing all the ice cubes together and dripping through the outlet
Either the icemaker support is broken, DA61-02205A\015\012 or the ice tray is damaged or has lime bui ...
Samsung RS2578BB Side by Side Refrigerator
I have a Kenmore side-by-side, model 253 54364405. I recently changed my ice maker, and now the dispenser won't dispense ice cubes, but it will water. The auger will not rotate, when you press the lever. Where is teh ice tray supposed to hit the motor at to rotate the auger.
Hi,The ice bin engages from the rear of the bin, the ice bin yoke should fit into the forks of the auger motor, but should be the opposite of the forks to work ( like a X ). I hope this helps. I would remove the ice bin from the freezer, depress ...
Kenmore 53642 / 53644 Side by Side Refrigerator